Mechanism of Micro-Crack Propagation in Semicrystalline Polymers

Authors

  • Theodor Stern Department of Chemical Engineering, Biotechnology and Materials, Faculty of Engineering, Ariel University, Israel

DOI:

https://doi.org/10.6000/1929-5995.2014.03.02.1

Keywords:

Crystalline morphology, fracture, micro-cracks, internal stress, high -density polyethylene (HDPE).

Abstract

The development and propagation of cracks is the principle reason for premature mechanical failure of polymeric materials. The well known and widely accepted fracture theories, namely the Griffith fracture theory and the Irwin model, both assume that fracture takes place through the presence of preexisting cracks in the polymer. These minor preexisting cracks, or micro-cracks, are practically present in most polymeric samples. The Griffith approach assumes that for any particular material, the fracture stress is controlled by the size of the flaws present in the structure.

The control and minimization of micro-crack size during polymer processing requires an understanding of the inherent micro-crack propagation mechanism.

The present research reveals a mechanism of internal stress-induced micro-crack propagation in semicrystalline polymers and describes the effect of the intricate crystalline morphological interactions on the extent and direction of intra-spherulite and inter-spherulite micro-crack propagation. In conclusion, a method for minimizing inter-spherulite micro-crack propagation is presented in this article.

References

Williams JG. Fracture of Polymers. Polym Eng Sci 1973; 17(3): 144-9. http://dx.doi.org/10.1002/pen.760170303 DOI: https://doi.org/10.1002/pen.760170303

Bank LC. Progressive Failure and ductility of FRP Composites for Construction: Review/ J Comoos Constr 2013; 17: 406-19. DOI: https://doi.org/10.1061/(ASCE)CC.1943-5614.0000355

Mallick PK, Fiber-Reinforced Composites, CRC Press, New York 2008. DOI: https://doi.org/10.1201/9781420005981

Young RJ, Lovell PA. Introduction to Polymers. 3rd ed., CRC Press, New York 2011. DOI: https://doi.org/10.1201/9781439894156

Bower DI. Introduction to Polymer Physics. Cambiridge University Press 2008.

Murray J, Hull D. Inherent Flaw Size and Fracture Energy of Polystyrene. J Mater Sci 1971; 6: 1277-85. http://dx.doi.org/10.1007/BF00552041 DOI: https://doi.org/10.1007/BF00552041

Hashemi S, Williams JG. Fracture from Inherent Flaw in Polymers. J Mater Sci 1985; 20: 4202-208. http://dx.doi.org/10.1007/BF00552415 DOI: https://doi.org/10.1007/BF00552415

Stern T, Wachtel E, Marom G. Origin, Morphology and Crystallography of Polyethylene-Based Single Polymer Composites. Composites Part A 1997; 28A: 437-44. http://dx.doi.org/10.1016/S1359-835X(96)00142-X DOI: https://doi.org/10.1016/S1359-835X(96)00142-X

Stern T, Wachtel E, Marom G. Epitaxy and Lamellar Twisting in Transcrystalline Polyethylene. J Polym Sci Part B: Polym Phys 1997; 35: 2429-33. http://dx.doi.org/10.1002/(SICI)1099-0488(19971115)35:15<2429::AID-POLB5>3.0.CO;2-O DOI: https://doi.org/10.1002/(SICI)1099-0488(19971115)35:15<2429::AID-POLB5>3.0.CO;2-O

Downloads

Published

2014-06-24

How to Cite

Stern, T. (2014). Mechanism of Micro-Crack Propagation in Semicrystalline Polymers. Journal of Research Updates in Polymer Science, 3(2), 57–62. https://doi.org/10.6000/1929-5995.2014.03.02.1

Issue

Section

Articles